ICND1 Labs CCNA ICND1 Lab1 – Basic Switch Command (1) CCNA ICND1 Lab1 – Basic Switch Command (2) CCNA ICND1 Lab2 – Restore Switch Password CCNA ICND1 Lab3 – Routing Between VLANs…
Tag: ICND2 Lab
CCNA ICND2 Lab15 – Access List
Lab Tips: The ACL is a security solution that filters packets when they pass through a router. ACLs are divided into standard ACLs and extended ACLs. To pass the CCNA exam, please…
CCNA ICND2 Lab14 – Frame Relay
Lab Tips: The Frame-Relay protocol is a data-link layer packet switching protocol that is used in the line. The line only checks errors. These errors are solved by the upper-layer protocols such…
CCNA ICND2 Lab13 – CHAP Authentication
Lab Tips: PPP supports device authentication through the two following protocols: PPP Authentication Protocol (PAP) and Challenge Handshake Authentication Protocol (CHAP). CHAP processes the password through Basic MD5 HASH algorithm and sends…
CCNA ICND2 Lab12 – PAP Authentication
Lab Tips: PPP supports device authentication through the two following protocols: PPP Authentication Protocol (PAP) and Challenge Handshake Authentication Protocol (CHAP). PAP is easier but not safe. Through two handshakes, the sender…
CCNA ICND2 lab11 – EIGRP Routing Protocol
EIGRP Routing Protocol A: Lab Tips: Enhanced Interior Gateway Routing Protocol (EIGRP) is a proprietary Cisco IP routing protocol. Lab Requirements: 1. Perform basic routing configurations. 2. Use loopback interfaces to replace…
CCNA ICND2 Lab 10 – Configure OSPF Protocol in a Single Area
Lab Topology: Lab Requirements: 1. The router names are P4S1, P4S2 and P4S3.
CCNA ICND2 Lab 9 – Use Extended ACL to Block ping Command
Lab Topology: Lab Requirements: 1. The router names are P4S1 and P4S2.
CCNA ICND2 Lab 8 – Configure RIP Dynamic Route
Lab Topology: