Prepare to install and configure a Cisco Unified Communications Manager (CUCM) solution in a single site in this course, focusing primarily on CUCM Release 6.x/7.x, the call routing and signaling component for…
Category: CCVP
Voice
McGraw-Hill – Hacking Exposed VoIP Voice Over IP Security Secrets & Solutions
Block debilitating VoIP attacks by learning how to look at your network and devices through the eyes of the malicious intruder. Hacking Exposed VoIP shows you, step-by-step, how online criminals perform reconnaissance,…
CCVP TUC (642-426) Quick Learning
The following Quick Learning Modules are focused on a specific lesson or topic from the current TUC curriculum. This content is only accessible by Registered Users. If you have not yet registered,…
CCVP Qos (642-642) Quick Learning
The following Quick Learning Modules are focused on a specific lesson or topic from the current QOS curriculum. This content is only accessible by Registered Users. If you have not yet registered,…
CCVP CVOICE (642-436) Quick Learning
The following Quick Learning Modules are focused on a specific lesson or topic from the current CVOICE curriculum. This content is only accessible by Registered Users. If you have not yet registered,…
CCVP CIPT2 (642-456) Quick Learning
The following Quick Learning Modules are focused on a specific lesson or topic from the current CIPT2 6.0 curriculum. This content is only accessible by Registered Users. If you have not yet…
CCVP CIPT1 (642-446) Quick Learning
The following Quick Learning Modules are focused on a specific lesson or topic from the current CIPT1 6.0 curriculum. This content is only accessible by Registered Users. If you have not yet…
CCVP-CIPT2 642-456-Update(April-2009) New Questions
Q1.Rank the steps for configuring AAR A. Configure AAR service parameters. B. Configure phones for AAR C. Configure partitions and CSSs. D. Configure AAR groups. Correct Answer: DACB
CCVP/CCIP QoS(642-642) Lab – DSCP & CoS
You are required to configure the fa0/1, fa0/10 and fa0/11 ports on the Cisco Catalyst 2950 switch according to the following: On port fa0/1, trust all incoming DSCP settings. On port fa0/11,…